D C Super Shine High Luster Finessing Kit

Description

D C Super Shine High Luster Finessing Kit

THIS KIT HAS BEEN IN THE WORKS FOR SOME TIME. IT HAS BEEN ASSEMBLED FOR THE PURPOSE OF REMOVING OR AT LEAST MINIMIZING SWIRLS AND POST-POLISHING MARKS IN ALUMINUM. THE BONNETS INCLUDED IN THE KIT FIT ARE MADE OF AN ULTRA-SOFT FLANNEL MATERIAL THAT WILL LEAVE A BRIGHT SWIRL-FREE FINISH.  THESE BONNETS FIT SNUGLY OVER TOP OF A 6” WOOL PAD, ALSO INCLUDED IN THE KIT. THE BRIGHT WORK BLUE METAL POLISH IN THIS KIT IS A VERY FINE POLISH THAT IS PERFECTLY SUITED TO THE USE OF THE ULTRA-SOFT BONNETS. TO GET THE DESIRED RESULTS, AN ORBITAL POLISHER MUST BE USED WITH THIS KIT. IF YOU NEED AN ORBITAL POLISHER, WE OFFER THE PORTER CABLE RANDOM ORBITAL POLISHER UNDER THE CATEGORY, “POLISHERS, SANDING DISCS, ETC.”

THE COMPONENTS OF THIS KIT ARE AS FOLLOWS:

ONE 8 OZ. JAR OF BRIGHT WORK BLUE FINISHING METAL POLISH

ONE 4 ¾” DIAMETER HOOK & LOOP BACKING PLATE

ONE SM ARNOLD 6” WOOL PAD

FOUR ULTRA SOFT BONNETS

ONE TWO-PACK OF MICROFIBER APPLICATORS

IN ORDER TO ACHIEVE THE BEST RESULTS, THE PROCEDURE WORKS AS FOLLOWS:

1.   USING THE METAL POLISH VERY SPARINGLY, APPLY WITH THE MICROFIBER APPLICATOR A LIGHT COATING TO THE SURFACE BEING POLISHED. (***SEE NOTE BELOW) 

2.   MOUNT THE HOOK & LOOP BACKING PLATE INCLUDED IN THE KIT TO YOUR ORBITAL POLISHER. PLACE THE 6” WOOL PAD ALSO INCLUDED IN THE KIT TO THE BACKING PLATE.

3.   STRETCH THE ULTRA-SOFT BONNET OVER THE 6” PAD. NOTE: THIS WILL BE A VERY SNUG FIT, BUT SUCH IS NECESSARY TO KEEP THE BONNET FROM SPINNING OFF. 

4.   USING THE ORBITAL POLISHER, GO OVER THE SURFACE AREA UNTIL RELATIVELY CLEAN.

5.   REMOVE THE USED BONNET FROM THE 6” WOOL PAD AND STRETCH A SECOND CLEAN ULTRA-SOFT BONNET OVER THE PAD.

6.   POLISH THE SURFACE AGAIN TO REMOVE ANY REMAINING RESIDUE AND FINISH THE PROCESS.

*** D C SUPER SHINE PREFERS TO APPLY A SMALL THUMB SIZE AMOUNT TO THE BONNET ITSELF. THIS WOULD BE DONE AFTER STEP 3.